Table of Contents
Advertisement
INSTALLATION & SETUP
This section explains how to install and set up the projector. If you are familiar with the projector and want to
quickly set it up for temporary use, follow the Quick Setup instructions below. For a more complete setup, fol-
low the instructions and guides covered in the remaining subsections.
NOTE: 1) The lens is not mounted when the projector is shipped from the factory. For instructions on how to
install or replace a lens, refer to 4.5, Replacing the Lens.
2.1
Quick Setup
Follow these steps for quick setup of the projector in a standard floor mount position.
STEP 1
Position the Projector
Set the projector at the expected throw distance (projector-to-screen distance) and vertical posi-
tion. See 2.3, Projector Position and Mounting and Appendix E. Make sure that the projector is
level from side-to-side (see 2.7, Leveling).
STEP 2
Connect a Source
Locate the main input panel at the rear of the projector. The lower left area, labeled INPUT 1,
accepts an RGB input via BNC connectors. The upper right area (assuming a video decoder is
installed) accepts a composite video at INPUT 3 or S-video input at INPUT 4. Connect your
source to the appropriate panel connectors.
STEP 3
Connect the Line Cord to AC Power
Connect the projector's 13 amp high-current rated line cord to the AC receptacle at the lower
right corner of the projector and to AC. Input power required is 100 - 240 VAC, 50 to 60 Hz @
11.5 amps (@ 100 V). Use only a high-current 13 amp rated cord. See Section 5.
!
STEP 4
Turn the Projector ON
Using either the built-in or remote keypad, press
turn the projector on (or press
The POWER LED, located in the lower right corner of the rear input panel, should glow a
steady green.
STEP 5
Select a Source
Using either the built-in or remote keypad, press
the image for the source you connected in Step 2. The display will resize as needed, producing
an image as large as possible for the type of source present.
Do not attempt operation if the AC supply and cord are not within the
specified voltage and power range.
Power*
WARNING
and hold for approximately 1 second to
Power*
). Let the projector warm up for about five minutes.
ON
,
Input1
Input1
2-1
,
, or
to select and display
Input1
Input1
Advertisement
Table of Contents
