Using Hdmi Cec Messages; Cec Command List - Runco XtremeProjection X-200i Installation & Operation Manual

The X-200i accepts and can respond to CEC command messages from a disc player,
satellite receiver or DVR/set-top box via an HDMI connection. Using CEC, the X-200i can
perform the following actions:
• Turn itself on and select the correct input when the source component initiates
playback of a disc or recorded program.
• Turn the source component on when you switch to its corresponding input on the
X-200i.
• Turn the source component off when the X-200i is turned off (unless the source
component is in playback mode).
• Change its OSD language when a similar change is made at the source.
To use CEC, connect your CEC-compatible sources to the HDMI inputs on the X-200i.
Set the HDMI CEC option to On (refer to HDMI CEC on page 71). Additional steps may
be needed to enable CEC at the source. Refer to the documentation for your source
device for more information.
Table 6-4 lists the CEC commands supported by the X-200i.
Table 6-4. CEC Commands Supported by the X-200i
Opcode
Feature Abort
Image View On
Set Menu Language
Standby
User Control Pressed
User Control Released
Give OSD Name
Set OSD Name
Vendor Remote Button Up
Active Source
Give Physical Address
Report Physical Address
Request Active Source
Set Stream Path
Device Vendor ID
Vendor Command
Runco X-200i Series Installation/Operation Manual
Value Parameters
0x00 [Feature Opcode]
[Abort Reason]
0x04 None
0x32 [Language]
0x36 None
0x44 [UI Command]
0x45 None
0x46 None
0x47 [OSD Name]
0x5B [Vendor Specific RC
Code]
0x82 [Physical Address]
0x83 None
0x84 [Physical Address]
[Device Type]
0x85 None
0x86 [Physical Address]
0x87 [Vendor ID]
0x89 [Vendor Specific Data]
Directly
Broadcast
Addressed
Yes No
Yes No
No Yes
Yes Yes
Yes No
Yes No
Yes No
Yes No
Yes Yes
No Yes
Yes No
No Yes
No Yes
No Yes
No Yes
Yes No
93
External Control
6.3
Using HDMI CEC
Messages

CEC Command List