The DHD Controller accepts and can respond to CEC command messages from a disc
player, satellite receiver or DVR/set-top box via an HDMI connection. Using CEC, the DHD
Controller can perform the following actions:
• Turn itself and the projector on and select the correct input when the source
component initiates playback of a disc or recorded program.
• Turn the source component on when you switch to its corresponding input on the DHD
Controller.
• Turn the source component off when the VX-11d system is turned off (unless the
source component is in playback mode).
• Change its OSD language when a similar change is made at the source.
To use CEC, connect your CEC-compatible sources to the HDMI inputs on the DHD
Controller. Set the CEC option to On (refer to CEC on page 80). Additional steps may be
needed to enable CEC at the source. Refer to the documentation for your source device
for more information.
Table 6-3 lists the CEC commands supported by the DHD Controller.
Table 6-3. CEC Commands Supported by the DHD Controller
Opcode
Feature Abort
Standby
Routing Change
Routing Information
Active Source
Request Active Source
Device Vendor ID
Give Device Vendor ID
Vendor Command With ID
Polling Message
Text View On
Report Physical Address
Inactive Source
CEC Version
Set OSD Name
Menu Status
Report Power Status
Set Menu Language
Runco VX-11d Installation/Operation Manual
Supported? (√ = Yes, – = No)
Value
Initiator
√
0x00
√
0x36
√
0x80
√
0x81
√
0x82
√
0x85
√
0x87
√
0x8C
√
0xA0
√
N/A
√
0x0D
√
0x84
√
0x9D
√
0x9E
√
0x47
√
0x8E
√
0x90
0x32
–
Follower
√
√
√
√
√
√
√
√
√
√
–
–
–
–
–
–
–
√
103
External Control
6.3
Using HDMI CEC
Messages
CEC Command List