I Programming A Call Channel; Call Channel Operation - Icom IC-E208 Instruction Manual

I Programming a call channel

Operating frequency, duplex information, subaudible tone in-
formation (tone encoder or tone squelch ON/OFF and its fre-
quency) can be programmed into the call channel.
q Set the desired frequency in VFO mode.
➥ Push [V/MHz•SCAN] to select VFO mode.
➥ Set the frequency using [DIAL].
➥ Set other data as desired.
w Push [S.MW•MW] momentarily.
e Rotate [DIAL] to select the desired call channel.
• "!" indicator and "C1" or "C2" blink.
r Push [S.MW•MW] for 1 sec. to program.
• 3 beeps sound and the unit returns to VFO mode automatically.
[EXAMPLE]: Programming 145.120 MHz into the call channel 2 via the microphone.
Push to select VFO mode.
Push until "C2" appears.
MR/CALL
MW
[Y]/[Z]
Set the frequency.
Push , then push for 1 sec.

CALL CHANNEL OPERATION

z Set the desired frequency in VFO mode.
➥ Push [VFO/LOCK] to select VFO mode.
➥ Set the frequency.
➥ Set other data as desired.
x Push [FUNC], then [
A(MW)] momentar-
CLR
ily.
c Select the call channel via [Y] or [Z].
v Push [FUNC] then [
A(MW)] for 1 sec. to
CLR
program.
• 3 beeps sound and the unit returns to VFO mode
automatically.
Push , then .
➠
"
"
Beep
"
Beep
"
Beep
"
6
6
38