I Offset Frequency - Icom IC-E208 Instruction Manual

I Offset frequency

When communicating through a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
Independent offset frequencies can be set for each operating
frequency.
q Push [BAND] to select the desired frequency band.
wSelect the desired mode/channel you wish to set the offset
frequency, such as VFO mode or memory/call channel.
• The offset frequency can be independently programmed into
each mode or channel.
e Push [SET•LOCK] to enter set mode.
rPush [SET•LOCK] or [S.MW•MW] until "DUP" and offset
frequency appear.
[SET•LOCK]
t Rotate [DIAL] to set the desired offset frequency.
y Push [V/MHz•SCAN] to exit set mode.
[
"DUP" and offset frequency appear
REPEATER OPERATION
z Push [BAND] to select the desired frequency
SET
band.
B
• Enter the desired frequency via the keypad if neces-
sary.
x Select the desired mode/channel you wish to
set the offset frequency, such as VFO mode or
memory/call channel.
• The offset frequency can be independently pro-
grammed into each mode or channel.
c Push [
B(D-OFF)] to enter set mode.
SET
v Push [
B(D-OFF)] or [
SET
"DUP" and offset frequency appear.
Push
b Push [Y] or [Z] to set the desired offset.
• Direct frequency entry from the keypad is not possi-
ble.
n Push [
A(MW)] to exit set mode.
CLR
NOTE: The offset frequency can be set in a memory/call
channel temporarily. However, the set frequency is cleared
once another memory channel or VFO mode is selected.
To store the offset frequency permanently, overwrite the
channel information.
4
4
C(T-OFF)] until
ENT
24