Icom IC-E208 Instruction Manual page 42

5
MEMORY OPERATION
D Programming a memory channel via the microphone
The microphone can also be used to program mem-
MW
ory channels.
z Set the desired frequency in VFO mode.
➥ Push [VFO/LOCK] to select VFO mode.
➥ Set the frequency using the keypad.
➥ Set other data
audible tone encoder ON/OFF and its frequency)
sary.
x Push [FUNC] then [
c Push [Y] or [Z] to select the memory channel.
•
Direct numeral input cannot be used
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel) via the microphone.
Push
Push 10 times
27
(e.g. offset frequency, duplex direction, sub-
A(MW)] momentarily.
CLR
.
Push
"
"
Beep
"
Beep
"
Beep
v Push [FUNC] then [
➥ 3 beeps may sound and the VFO contents (including
the subaudible tone frequency, etc.) are programmed.
➥ Memory channel number increases when continuing to
, if neces- push [
then for 1 sec. and continue to push
"
A(MW)] for 1 sec. to program.
CLR
A(MW)] after programming.
CLR
Push then
"
Beep
➠
"
Beep