Mixer Controls; Program Channels; Source Selector; Level - Rane SIXTY-ONE Operator's Manual

Mixer
Controls

Program Channels

Two Program channels, or buses,
have nearly identical controls with the
exception of the Source selectors.

Source Selector

The sOURcE selector for PGM 1 selects one
of four sources:
• PH / CD 1 (THRU): Set to PH or cD with the
rear panel switch.
• When selected in software, this input
is available on USB record 5-6 for use
as the DVS control signal or for audio
recording. To select this control source
in Serato Scratch Live: go to Setup >
Hardware > Control Source > PGM 1
and select "1". See "Control Source"
on page 36.
• PH / CD 2 (THRU): Set to PH or cD with the
rear panel switch.
• When selected in software, this input
is available on USB record 5-6 for use
as the DVS control signal or for audio
recording. To select this as the control
source in Serato Scratch Live: go to
Setup > Hardware > Control Source >
PGM 1 and select "2".
• Left Virtual Deck 1 (USB stereo playback
1-2).
• Right Virtual Deck 2 (USB stereo
playback 3-4).
The sOURcE selector for PGM 2 selects one
of four sources:
• PH / CD 3 (THRU): Set to PH or cD with the
rear panel switch.
• When selected in software, this input
is available on USB record 7-8 for use
8
as the DVS control signal or for audio
recording. To select this control source
in Serato Scratch Live: go to Setup >
Hardware > Control Source > PGM 2
and select "3".
• PH / CD 4 (THRU): Set to PH or cD with the
rear panel switch.
• When selected in software, this input
is available on USB record 7-8 for use
as the DVS control signal or for audio
recording. To select this control source
in Serato Scratch Live: go to Setup >
Hardware > Control Source > PGM 2
and select " ".
4
• Left Virtual Deck 1 (USB stereo playback
1-2).
• Right Virtual Deck 2 (USB stereo
playback 3-4).

Level

LEVEL controls adjust the input gain from
off to +15 dB. Unity gain (no boost or cut)
is at 12 o'clock.

Pan

Left / Right PAn controls adjust the balance
of left and right signals. Left and right are
equal at 12 o'clock.
RANE SIXTY-ONE MIXER FOR SERATO SCRATCH LIVE • OPERATOR'S MANUAL 2.4.4

Tone Controls

HIGH, MID and LOW full-cut tone controls
adjust the frequency response from off to
+6 dB. Unity gain (no boost or cut) is at 12
o'clock.

Filter

The FILTER sweeps from Low-Pass to
High-Pass. Set to 12 o'clock for a flat
frequency response. Moving the filter
toward the LOW position progressively
reduces high-frequencies. Moving the
filter toward the HIGH position progressively
reduces low-frequencies. The Resonance
or Q of the Filter can be adjusted in the
Setup screen for Hardware: Effects. See
"Hardware: Effects" on page 36.

FlexFx

The FLExFx button assigns a PGM channel
to the FlexFx bus where external analog
(with the AnALOG InsERT button) or software
effects via USB (with the
button) may be inserted, such as Scratch
Live DJ-FX. See "Enable DJ-FX" on
page 39.
The FlexFx loop allows any combination
of PGM 1, PGM 2, MIc or AUx to be
assigned to external analog effects or
software effects via USB.
InsERT