Mixer Controls; Program Channels; Source Selector; Level - Rane SIXTY-ONE Operator's Manual

MIXER CONTROLS

PROGRAM CHANNELS

Two Program channels, or buses, have nearly
identical controls with the exception of the
Source selectors.

SOURCE SELECTOR

The SOURCE selector for PGM 1 selects one of
four sources:
• PH / CD 1 (THRU): Set to PH or CD with the rear
panel switch.
• When selected in software, this input is
available on USB record 5-6 for use as the
DVS control signal or for audio recording.
To select this control source in Serato
Scratch Live: go to Setup > Hardware >
Control Source > PGM 1 and select "1".
"CONTROL SOURCE" ON PAGE 36
• PH / CD 2 (THRU): Set to PH or CD with the rear
panel switch.
• When selected in software, this input is
available on USB record 5-6 for use as the
DVS control signal or for audio recording. To
select this as the control source in Serato
Scratch Live: go to Setup > Hardware >
Control Source > PGM 1 and select "2".
• Left Virtual Deck 1 (USB stereo playback 1-2).
• Right Virtual Deck 2 (USB stereo playback
3-4).
8
The SOURCE selector for PGM 2 selects one of
four sources:
• PH / CD 3 (THRU): Set to PH or CD with the rear
panel switch.
• When selected in software, this input is
available on USB record 7-8 for use as the
DVS control signal or for audio recording. To
select this control source in Serato Scratch
Live: go to Setup > Hardware > Control
Source > PGM 2 and select "3".
SEE
• PH / CD 4 (THRU): Set to PH or CD with the rear
.
panel switch.
• When selected in software, this input is
available on USB record 7-8 for use as the
DVS control signal or for audio recording. To
select this control source in Serato Scratch
Live: go to Setup > Hardware > Control
Source > PGM 2 and select "
• Left Virtual Deck 1 (USB stereo playback 1-2).
• Right Virtual Deck 2 (USB stereo playback
3-4).

LEVEL

LEVEL controls adjust the input gain from off to
+15 dB. Unity gain (no boost or cut) is at 12
o'clock.

PAN

Left / Right PAN controls adjust the balance of
left and right signals. Left and right are equal at
12 o'clock.

TONE CONTROLS

HIGH, MID and LOW full-cut tone controls adjust the
frequency response from off to +6 dB. Unity gain
(no boost or cut) is at 12 o'clock.

FILTER

The FILTER sweeps from Low-Pass to High-Pass.
Set to 12 o'clock for a flat frequency response.
Moving the filter toward the LOW position
progressively reduces high-frequencies. Moving
the filter toward the HIGH position progressively
reduces low-frequencies. The Resonance or
".
4
Q of the Filter can be adjusted in the Setup
screen for Hardware: Effects.
EFFECTS" ON PAGE 36
RANE SIXTY-ONE FOR SERATO SCRATCH LIVE
SEE "HARDWARE:
.
• OPERATOR'S MANUAL 2.4