Page 1
So just this once—please—we highly recommend you read this entire manual: front-to-back, every single page, every single word. It will familiarize you with the many intricacies of the MP 24z, not to mention all the nooks and cran- nies.
20 21 22 1 POWER “ON” indicator: Illuminates anytime the MP 24z is connected to an appropriate power source (see k, Rear Panel). 2 SOURCE CONTROL selectors: Provide Input selection between the various Phono and Line Inputs for their respective mixing channels.
1. Remove (2) 3mm screws. faders as good as new. The fader assembly must be removed from 2. Draw fader assembly out through hole. the MP 24z for proper cleaning. We recommend any of the fol- 3. Remove ribbon cable. lowing cleaning solutions: Caig DeoxIT FaderLube F100 spray lubricant (www.caig.com)
5 MAXIMUM OUTPUT GAIN REDUCTION control: Decreases the maximum Level of the balanced and unbalanced MAIN OUTPUTS of the MP 24z as it is rotated counter-clockwise. 6 METER SENSITIVITY ADJUST: Clockwise rotation decreases the full-scale sensitivity of the PEAK PROGRAM METER, as indicated by the full-scale voltage calibrations around the control.
Page 5
Chassis ground point: Since the MP 24z does not get chassis ground through the AC cord, this point is provided in case your system does not have another earth ground such as the rack rails. A #6-32 screw and toothed washer is provided for chassis ground.
Page 6
This is a good place to discuss the problems encountered in LINE level Input. connecting the MP 24z to all of the different types of cables and When determining which Line Inputs to use for what, the connectors that one finds when basing a system on consumer process becomes a bit more difficult.
The contour of the Crossfade has been optimized for con- temporary use. However, the mix of the two input signals will MP 24z. If this is not possible, full system drive will not come from some components. To accomplish this feat, use identical have an impact on volume level as you fade from one input to the cartridges in all turntables so the phono levels are all the same.
CHASSIS GROUNDING the LIGHT OUTPUT LEVEL control, the signal delivered The MP 24z is supplied with a rear mounted ground-lift is amplified 20 dB relative to the pre-master fader level. If this switch. The unit is shipped with this switch in the “grounded”...
Need help?
Do you have a question about the MP 24Z and is the answer not in the manual?
Questions and answers