Scratch Live: Getting Started; System Overview; Connecting The Sixty-One; Turntable Setup - Rane SIXTY-ONE Operator's Manual

Scratch
Live: Getting
started

System Overview

The Scratch Live control records and
CDs are pressed with an audible tone
specifically developed for controlling the
Scratch Live software application.
The Sixty-One converts the control
signal coming from each deck into digital
audio, to be sent via USB to the Scratch
Live software, which decodes that signal
into a stream of information based on
what the DJ is doing with the control disc.
A virtual 'deck' replicates the movements
of the control disc. Audio files loaded
onto the Virtual Decks are then played
back through the outputs of the Sixty-
One, with any manipulation of the control
discs reproduced on the audio, effectively
emulating vinyl control of the files loaded
in software.

Connecting the Sixty-One

Follow these steps to set up the Sixty-
One for Scratch Live, using up to two
turntables or CD players to control the
software playback.
1. Inputs
Connect your CD players or turntables
to the AnALOG InPUTs on the Sixty-One.
Connect your left source to 1 or 2, and
your right source to 3 or 4. The default
control sources in Scratch Live are Inputs
1 and 3. You can change these in the
setup screen. See "Control Source" on
page 36.
Match the L channel from each of
your decks (usually white) with the white
(uppermost) RCA sockets on the mixer
and R (usually red) with the red sockets.
12
This is important to give Scratch Live
the correct direction of playback. If your
songs play backwards, you probably have
the left and right channels swapped from
your deck.
2. Input Level Selection
Set each input to the correct input level
using the PH - cD switches. PH = Phono and
cD = Line (for CD players). Unused inputs
are best set to cD.
3. USB Audio
Select Scratch Live as the audio source
for a channel by turning a PGM SOURCE
knob to a USB input. Any of the four
analogue inputs may be used for Scratch
Live vinyl emulation control. Control input
sources for both PGM 1 and PGM 2 are
selected in the Scratch Live setup screen.
4. Connect the Sixty-One to your
computer
Using the provided USB cable, connect
to an available USB 2.0 port on your
computer. Make sure you connect it
directly to your computer and not through
a hub or splitter.

Turntable Setup

1. Set the tone arms to the specific
recommendations of the cartridge
used, so that the needle never leaves
the record, but not heavy enough that
it heats up significantly. Both produce
poor tracking.
2. Grounding is extremely important when
using Scratch Live. Make sure you have
good connections from the ground wires
of your turntables to a grounding post
on the Sixty-One. If you do not ground
your turntables properly, the control
signal will be noisy and the tracking of
the record position will be erratic.

CD Player Setup

Disable all built-in effects on the CD
player, including keylock/master tempo.
RANE SIXTY-ONE MIXER FOR SERATO SCRATCH LIVE • OPERATOR'S MANUAL 2.4.4
Installing
Scratch Live
Check for the latest download version of
Scratch Live software at serato.com. If it
is newer than the version on your CD-
ROM, we recommend installing it instead.

Mac

1. Insert the Software Installation CD-
ROM and double-click the Scratch Live
Installer.mpkg icon.
or
Launch the installer you just
downloaded from serato.com.
2. Follow the on-screen instructions. Once
the installation is complete, Scratch Live
will appear in your applications list. You
may like to drag the Scratch Live icon to
your dock for quick launching.
3. Plug in your Sixty-One. No extra
installation is required to use Scratch
Live.