Headphone Cues; Channel Faders & Crossfader; Channel Meters; Mute Switches - Rane SIXTY-ONE Operator's Manual

The DRy / WET pan control lets you set
the amount of FlexFX in the Main Mix.
DRy equals no effect, WET gives maximum
effect.

Headphone Cues

Headphone cUE assigns a signal to
the headphone monitor. Headphone
Cue controls operate as solo or radio-
button controls. This means engaging
a headphone Cue turns all the other
headphone Cue controls off. You can
select more than one at a time by
simultaneously pressing more than one
cUE button.
Channel Faders & Crossfader
These faders use magnetic non-contact
mechanisms with no noise and no bleed.
Each fader has REVERsE and cOnTOUR
controls.

Channel Meters

Each PGM channel has a mono meter to
assist in setting levels. These meters are
quasi-peak with peak hold. The goal is to
stay out of the red.
The best method is to bring up a PGM
fader all the way, then adjust the channel
LEVEL control so that red flashes are rare to
none.

Mute Switches

These joysticks provide quick program
mute, much like transform switches on
the other mixers. The signal is ON in
the straight-up position, a push in any
direction kills the signal.
RANE SIXTY-ONE MIXER FOR SERATO SCRATCH LIVE • OPERATOR'S MANUAL 2.4.4

AUX

This digital input is on USB
playback stereo pair 5-6
and is normally used for the
Scratch Live SP-6 sample
player. This AUx input
has it's own LEVEL, FLExFx
assign and cUE.
To assign the SP-6
Sample Player to AUx,
click the SP-6 tab on the main Scratch
Live screen and select "A" as the SP-6
output. See "Enable SP-6 Sample
Player" on page 39.

Mic Input

This Mic input on a
XLR/TRS combo jack
has LEVEL, HIGH and LOW
tone controls, FLExFx
assign and a meter.
Select MIc or LInE level
using the rear panel
switch. LInE is usually
correct for wireless
mic receivers. The Mic
is OFF when the LEVEL
control is at "0".

Session In and Out

The sEssIOn In has it's own
LEVEL control and may be
used as a general purpose
analog RCA jack AUX input.
The sEssIOn OUT has it's
own LEVEL control and
may be used as a general
purpose RCA jack Main Mix
output.
sEssIOn In and sEssIOn OUT
are typically used to chain
mixers together.

Main Out

The Main outputs have a
Level control and a quasi-
peak stereo meter with
peak hold.

Headphones

The Headphone monitor
provides stereo or mono
split-cue operation.
• In Stereo operation, the
PAn control pans between
stereo Cue and stereo
Main Mix.
• In sPLIT cUE operation, the
PAn control pans between
Mono Cue in the left ear and mono Main
Mix in the right ear.
• Individual cUE buttons are provided for
PGM 1, PGM 2, AUx and FLExFx.
• The Headphone Level control sets the
level coming from both of the front
panel 3.5 mm and ¼˝ output jacks.
9