Troubleshooting - ProScan PS8600P User Manual

TROUBLESHOOTING
DVD Problem
Subtitle and/or audio
language is not the one
selected from the
initial setting
Solution
If the subtitle and/or audio language does not exist on the disc, the
initial settings will not be seen/heard. The disc's priority language is selected
instead. Set the subtitle and or audio language initial setting manually.
No on-screen display The OFF setting is selected for OSD Display; select ON in the Setup menu.
The menu is displayed in a The Menu Language preference is set to that language. Go to the
a foreign language Setup menu and select the language you prefer. Set the Start Up Language menu to
ON to have the player remember the language you selected.
Play doesn't begin when The rating level has been set and the disc is subject to that restriction.
a title is selected
No forward or reverse scan
Disc won't play
Desired angle cannot be changed
Picture is not displayed
with correct aspect ratio
Forgot Rating Limit Password
Cannot copy discs to video tape
Self-Diagnostic Message Solution
U 11 The disc is dirty. Wipe the discs with a soft cloth.
H
Some DVDs have sections that prohibit rapid scanning.
Both the player and the DVD is coded by region. If the regional codes don't match,
the disc cannot be played. This player is Code 1.
Some DVDs do not have the multi-camera angle system, and some discs have it
only on certain portions.
Make sure the TV SCREEN feature in the Setup menu is set correctly for your
television.
With the power on, press and hold the SKIP REV, PAUSE, and POWER buttons on
the player. This resets the password feature and all other settings to the initial
factory settings. INITIALIZED appears on the TV screen. You may be required to
select a menu language the next time you power up.
This player is equipped with anticopy protection.
When you see a code that begins with "H", it means that the unit is not
functioning properly. Turn the unit off and on again by pressing POWER twice or
unplug the AC power cord from the wall outlet, and then plug the unit back in.
This will make the unit operate normally if external electrical influences such as
lightning or static electricity have affected the operation of the unit.
64 Reference