Running The Symbios Configuration Utility - NEC EXPRESS 5800 ES1400 SERIES Online Service Manual

Symbios Configuration Utility
The Symbios Configuration Utility detects the SCSI host adapter located on the system board. Use
the utility to:
n Change adapter and SCSI device default values
n Check and/or change SCSI device settings that may conflict with those of other devices in the
server.
n Perform low-level formatting or verify operations on SCSI disk drives.

Running the Symbios Configuration Utility

1. Power-on the system. The system boots up.
2. When this message appears on the video monitor:
Press Ctrl-C to start the Symbios Configuration Utility
Press
The utility starts and the Main Menu displays.
3.
Adapter Port Number
SYM53C875 F800
Change Adapter Status – Press ENTER twice to change adapter Next Boot Status.
Adapter Boot Order – Press ENTER to select and change boot order of each SCSI adapter.
Additional Adapter Configuration – Not used.
Display Mode-Verbose – Press ENTER to change display mode.
Mono/Color – Press ENTER to change display from black/white to color.
Language
Help
Quit
*Next Boot Status for this controller must be turned
board in your system. Refer to "Change Adapter Status" above.
The following keys are active for all SCSI Configuration screens:
Key
Arrows
ENTER
ESC
3-18 Configuring Your System
to run this utility.
Ctrl+C
Symbios Configuration Utility Main Menu
IRQ Level
Current
11 On
OFF
Action
Up and down arrows move from one parameter to another within a screen.
Displays options for a configurable parameter. Selects an option.
Moves back to previous screen or parameter or EXIT if at the Main menu.
Status
Next Boot
On*
if you install the optional Mylex AcceleRAID 250 Controller
NVRAM Found
Yes