Symbios Configuration Utility; Running The Symbios Configuration Utility - NEC ES1400 User Manual

Symbios Configuration Utility

The Symbios Configuration Utility detects the SCSI host adapter located
on the system board. Use the utility to:
Change adapter and SCSI device default values
!
Check and/or change SCSI device settings that may conflict with
!
those of other devices in the server.
Perform low-level formatting or verify operations on SCSI disk drives.
!

Running the Symbios Configuration Utility

1. Power-on the system. The system boots up.
2. When this message appears on the video monitor:
Press Ctrl-C to start the Symbios Configuration Utility
Press Ctrl+C to run this utility.
3. The utility starts and the Main Menu displays.
Adapter Port
Number
SYM53C875 F800
Change Adapter Status – Press ENTER twice to change adapter Next Boot Status.
Adapter Boot Order – Press ENTER to select and change boot order of each SCSI adapter.
Additional Adapter Configuration – Not used.
Display Mode-Verbose – Press ENTER to change display mode.
Mono/Color – Press ENTER to change display from black/white to color.
Language
Help
Quit
*Next Boot Status for this controller must be turned OFF if you install the optional
Mylex AcceleRAID 250 Controller board in your system. Refer to "Change Adapter
Status" above.
The following keys are active for all SCSI Configuration screens:
Key
Arrows
ENTER
ESC
Symbios Configuration Utility Main Menu
IRQ Level
Current
11 On
Action
Up and down arrows move from one parameter to
another within a screen.
Displays options for a configurable parameter. Selects
an option.
Moves back to previous screen or parameter or EXIT if
at the Main menu.
Status NVRAM
Found
Next Boot
On* Yes
Configuring Your System 3-19