NEC EXPRESS 5800 ES1400 SERIES Online Service Manual page 147

n Valid IDE configurations are:
Connector
Secondary
Primary
Referring to the "SCSI Disk System Cable Configuration" Figure, one of the options available for
your system is to use the on-board SCSI controller to control wide SCSI hard disk drives in the
internal bay. In this case, a SCSI cable (C) connects the wide SCSI connector to the wide SCSI hard
disk drives in internal bay (B).
A terminator (A) must be plugged into the end of the SCSI cable. When using SCSI hard disk
drives, the SCSI address assignment is:
BAY DEVICE
CD-ROM (master)
HD3 or Tape (slave)
HD1 (master)
HD2 (slave)
SCSI ID ASSIGNMENT
First Hard Disk
Second Hard Disk
Third Hard Disk
Fourth Hard Disk
Tape Drive
Device
ADDRESS
0
1
3
4
2
System Cabling A-5