NEC EXPRESS 5800 ES1400 SERIES Online Service Manual page 96

Removing the Removable Media Drive Bay
1. Power off the system and remove both side panels and top cover as described earlier in this
chapter.
Remove the front panel as described earlier in this chapter.
2.
Disconnect the power cables (A) and ribbon data cables (B) from the devices installed in the
3.
drive bay.
Note:
bay.
Remove the screws securing the drive bay to the front of the chassis.
4.
5. Support the bottom of the drive bay and remove the two screws securing the drive bay to the
top of the chassis.
Remove the drive bay from the chassis and place it on an antistatic surface.
6.
Installing the Removable Media Drive Bay
Power off the system and remove both side panels and top cover as described earlier in this
1.
chapter.
4-36 Upgrading Your System
A
Removing Drive Cables
It is not necessary to remove the devices from the drive
Removing the Removable Media Drive Bay
B