Symbios Configuration Utility; Running The Symbios Configuration Utility - NEC LC1400 Service & Reference Manual

Symbios Configuration Utility

The Symbios Configuration Utility detects the two SCSI host adapters located
on the system board. Use the utility to:
n
Change adapter and SCSI device default values
n
Check and/or change SCSI device settings that may conflict with those of
other devices in the server.
n
Perform low-level formatting or verify operations on SCSI disk drives.

Running the Symbios Configuration Utility

1. Power-on the system. The system boots up.
2. When this message appears on the video monitor:
Press Ctrl-C to start the Symbios Configuration Utility
Press Ctrl+C to run this utility.
3. The utility starts and the Main Menu displays.
Adapter Port
Number
SYM53C875 F800
SYM53C875 F400
Change Adapter Status – Press ENTER twice to change adapter Next Boot Status.
Adapter Boot Order – Press ENTER to select and change boot order of each SCSI adapter.
Additional Adapter Configuration – Not used.
Display Mode-Verbose – Press ENTER to change display mode.
Mono/Color – Press ENTER to change display from black/white to color.
Language – Not used.
Help/Quit
*Next Boot Status for this controller must be turned OFF if you install the optional
Mylex AcceleRAID
Controller board in your system. Refer to "Change Adapter Status" above.
3-18 Configuring Your System
Symbios Configuration Utility Main Menu
IRQ Level
11
10
™
150 (SecuRAID 110) or Mylex AcceleRAID
Status
Current Next Boot
On On*
On On*
™
250 (SecuRAID 210)
NVRAM
Found
Yes
Yes