Replacing the Speaker
1.
Power off the system and remove the left side panel as described earlier in this chapter.
2.
The speaker is supported by three tabs (A) and is located at the front of the chassis as shown in
the following illustration.
Tag and disconnect the speaker cable from the system board.
3.
Slide the speaker upwards and out of the three tabs (A) to remove it from the chassis.
4.
Slide the replacement speaker downwards into the three tabs (A).
5.
Connect the speaker cable to the system board.
6.
Install the side panel as described earlier in this chapter.
7.
8.
Power on the system.
4-44 Upgrading Your System
A
Replacing the Speaker
Power LED
Speaker
Hard Disk Drive LED
Power Switch