Table of Contents
Advertisement
iSM14449: Set SNMP Trap Information :
number=<aa>h, Trap Sense
Interval=<bb>, Unit
Contact="<ccc...c>", Unit
Name="<ddd...d>", Unit
Location="<eee...e>", Unit
Info="<fff...f>", status=<ggg...g>
[Classification]
INFO
[Explanation]
It indicates that SNMP trap information was specified. Information specified
here becomes valid after resetting disk array or service processor.
aa
bb
ccc...c
ddd...d
eee...e
fff...f
ggg...g
[Measures]
When an error occurs (status=failed was output), the configuration or setting of
the disk array may be changed. After updating it to the newest information or
restarting state monitoring, check current state and execute again.
: Service processor number
: Trap monitoring interval (unit: second)
: Management information (administrator of disk array, managing
department, and contact address)
: System name (nickname of disk array, using host name, etc.)
: Installation site (installation sited of disk array)
: Supplementary information (other information required for
managing)
: Command execution status
good
: Normal
failed(xxxx) : Error occurred (xxxx is error description)
----
: Interrupted
377
Chapter 2 Message List
Advertisement
Table of Contents
