Fuse Box Assembly - VKI Technologies 2001 Operation And Service Manual

SUPREMA 2001 - OPERATION & SERVICE MANUAL
REMOVING THE FUSE BOX ASSEMBLY
$
Tip:
Whenever the fuse
box is removed,
make sure you
inspect the wiring
and the tabs inside
the box before re-
installing it.
INSTALLING THE FUSE BOX ASSEMBLY
Suprema 2001 - Operation & Service
1. Switch off the machine power and disconnect the service cord from the
wall outlet.
2. Remove the brewer.
3. Remove the brewer bracket assembly.
4. Disconnect the wires identified in the table below.
WIRE
#3-2
on fuse box harness
#3-3
on fuse box harness
#5
on fuse box harness
#6-1
on fuse box harness
#7-1
on fuse box harness
#6-3
on fuse box harness
#7-3
on fuse box harness
#2
on fuse box harness
#11
on fuse box harness
5. Disconnect the ground wire attached to the left wall of the machine.
6. Remove the two screws securing the fuse box.
7. Lift and pull on the fuse box to remove it.
1. From inside the cabinet, put the service cord through the fuse box location
cutout in the back of the cabinet.
2. Place the fuse box into position.
3. Align the holes on the fuse box with the holes on the cabinet wall.
4. Secure with two screws.
5. Connect the wires identified in the table below.
WIRE
#3-2
on fuse box harness
#3-3
on fuse box harness
#5
on fuse box harness
#6-1
on fuse box harness
#7-1
on fuse box harness
#6-3
on fuse box harness
#7-3
on fuse box harness
#2
on fuse box harness
#11
on fuse box harness
*
For more information about wiring, consult the
6. Connect the ground wire to the cabinet wall.
7. Replace the brewer bracket assembly.
8. Replace the brewer.
9. Plug in the service cord.
10. Switch the coffee maker "ON".
July 6, 2001
CONNECTED TO:
#11 on water tank harness
#12-3 on general harness
Ground stud on rear board cover
Inlet Valve
Inlet Valve
#6 on water tank harness
#1-2 on water tank harness
#10-1 on general harness
Stud #3 on heater relay
CONNECTED TO:
#11 on water tank harness
#12-3 on general harness
Ground stud on rear board cover
Inlet Valve
Inlet Valve
#6 on water tank harness
#1-2 on water tank harness
#10-1 on general harness
Stud #3 on heater relay
wiring section of this manual.
Page 53 of 60