Water Tank Assembly - VKI Technologies 2001 Operation And Service Manual

SUPREMA 2001 - OPERATION & SERVICE MANUAL
REMOVING THE WATER TANK ASSEMBLY
CAUTION:
Page 46 of 60
1. Switch the coffee maker "OFF".
2. Drain the water tank.
a) Place a heat-resistant and leak-proof container beneath the water tank.
b) Remove the top clip on the drain plug and push the drain plug upwards.
The bottom clip will act as a stopper.
Water coming out of the water tank may be extremely hot. Use caution
when removing the outlet valves.
3. Remove the brewer.
4. Disconnect the inlet hose.
a) Remove the hose clamp securing the inlet hose to the inlet fitting.
5. Remove the valve cover on the water tank.
6. Remove the hose from the hot water valve.
7. Remove the hose fitting from the whipper motor (if installed).
8. Disconnect the water tank harness from the rear board.
9. Disconnect the temperature probe harness from the rear board.
10. Disconnect the wires identified in the table below.
WIRE
#1-2
on General Harness
#8-1
on General Harness
#11-1
on Tank Harness
#6
on Tank Harness
#1-2
on Tank Harness
#11
on Fuse Box Harness
#13-1
(ground wire)
*
For more information about wiring, consult the
11. Carefully slide the water tank forward and out of the machine.
July 6, 2001
CONNECTED TO:
Whipper Motor
Whipper Motor
Wire #3-2 on Fuse Box Harness
Inlet Valve
Inlet Valve
Stud #3 on Heater Relay
Ground Stud on Rear Board Cover
wiring section
Suprema 2001 - Operation & Service
of this manual.