Total Counter Reset" Access Code; Set-Up Mode - VKI Technologies 2001 Operation And Service Manual

SUPREMA 2001 - OPERATION & SERVICE MANUAL
TOTAL COUNTER RESET

"TOTAL COUNTER RESET" ACCESS CODE

!
Note:
When the reset is
complete, the unit
will automatically
exit to the
"standby" mode,
and the internal
light will remain
" " temporarily.
ON
Suprema 2001 - Operation & Service
This software contains a special access code that enables the service person to reset all
the counters to zero, including the "
performed before a unit is re-installed in the field.
1. To perform a "
TOTAL COUNTER RESET
a) Switch the power to the coffee maker "
unit).
b) Press the "
SET
depressed.
c) With "
-
SET
d) The following message will now appear on the display,
e) Enter the "
TOTAL COUNTER RESET
The following is the factory preset "
following in the sequence outlined below;
Once the access code has been entered, a counter will appear on the top left of the
display, and will quickly increment from 0 to 255. Once this is complete, press
" " for the brewer to cycle once to re-establish its home position.
START
VEND TOTAL
" mode button on the inside door panel and keep it
-
UP
" mode button pressed, switch power to coffee maker "
UP
ENTER ACCESS
CODE:
" access code (described below).
TOTAL COUNTER RESET
1 COFFEE
2 MILD STRENGTH
3 LARGE CUP
4 MEDIUM CUP
5 SMALL CUP
July 6, 2001
" counter. This operation should be
",
" (switch is at the rear of the
OFF
" access code - press the
".
ON
Page 15 of 60