Table of Contents
Advertisement
SUPREMA 2001 - OPERATION & SERVICE MANUAL
Reminder: The "
INCREASE
button, and the "
left of the "
PRODUCT ON/OFF
!
Note:
If the product is
switched "
", it
OFF
remains off until
you enter the "
-
SET
" mode to
UP
switch it "
"
ON
again. Please
make sure it is
switched "
"
ON
before you leave
the account.
SETTING PRODUCTS
!
Note:
The minimum
allowable setting
for all products is
0.5 seconds, and
the maximum is
8.0 seconds.
$
Tip:
While in the "
SET
PRODUCT
" or "
SET
WATER
" menus, you
can test the product
and water quantities
by pressing the
START
"
" button. The
product or water
tested will
correspond to the
LED's illuminated
on the front
selection panel.
Make certain you
have something
ready to catch the
coffee grounds or
water that will be
dispensed.
Suprema 2001 - Operation & Service
" (+) and "
DECREASE
MENU SCROLL UP
" button. See page 4 for illustration.
START
This feature allows you to run a complete coffee or hot chocolate cycle (including the
two pauses) without any product being dispensed (no coffee or chocolate). This will
allow you to manually test brew different coffee blends for the customer to taste. The
customer can then decide which blend he prefers. To use it as a test brew cycle, simply
weigh and manually pour the coffee grounds into the brew chamber, and press the
"
" button. This procedure can be repeated if you need to test brew another blend.
START
1. To switch the product
scroll buttons and scroll until the following message appears,
a) Press the "
b) Switch the product "
buttons. Press the "
c) To exit the "
press the hidden "
1. To adjust product settings, press the "
scroll buttons and scroll until the following message appears,
a) Press the "
b) At this point, you can now select the product settings for any cup size,
product and product strength by pressing the appropriate buttons on the
selection panel. The time setting displayed will correspond to the LED's
that are illuminated.
c) Using the hidden setting adjustment buttons, increase or decrease the
timing for the product.
d) To exit the "
the hidden "
" (-) buttons are located to the right of the "
" and "
MENU SCROLL DOWN
, press the "
OFF
UP
PRODUCT ON/OFF
PRESS <START>
" button to enter set mode.
START
" or "
" by using the hidden setting adjustment
OFF
ON
" button to toggle it "
UP
on-off" mode and proceed to the next setting,
PRODUCT
" or "
" scroll buttons.
UP
DOWN
UP
SET PRODUCT
PRESS <START>
" button to enter the set mode.
START
" mode and proceed to the next setting, press
SET PRODUCT
" or "
" scroll buttons.
UP
DOWN
July 6, 2001
START
" buttons are located to the
" button on the hidden menu
" or "
".
OFF
ON
" button on the hidden menu
Page 17 of 60
"
Advertisement
Table of Contents
