Drain Valve - VKI Technologies 2001 Operation And Service Manual

SUPREMA 2001 - OPERATION & SERVICE MANUAL
REMOVING THE DRAIN VALVE
WARNING:
INSTALLING THE DRAIN VALVE
!
Note:
The center tube at
the bottom of the
tank is for the
water inlet hose
fitting, and the
rear tube is not
.
used
Suprema 2001 - Operation & Service
To remove the drain valve on a plastic water tank, it will be necessary to drain and
completely remove the tank from the coffee maker. The drain plug can only be
removed from the interior of the water tank.
1. Remove the water tank.
a) Refer to the
To avoid severe burns, make absolutely certain that the heater element is
not hot before proceeding!
2. Remove the drain valve.
a) Remove the upper and lower clips on the drain plug.
b) Push drain plug upwards until it goes through the bottom of the tank (to
the inside).
c) Remove the tank lid.
d) Reach inside the tank and remove drain plug.
1. Install the drain valve.
a) Remove tank lid.
b) Add new o-rings to the drain valve.
c) From the top of the tank, push the drain valve through the bottom (front
tube).
d) Install the clips. The smaller clip goes on the top slot, and the larger goes
on the bottom slot of the drain valve.
"Removing the Water Tank" instructions in this manual.
July 6, 2001 Page 49 of 60