Running Copper Tubing - VKI Technologies 2001 Operation And Service Manual

SUPREMA 2001 - OPERATION & SERVICE MANUAL

RUNNING COPPER TUBING

If the position of the coffee maker is near the water source, by far the simplest route for
the tubing is along the baseboard or straight down the wall. In both cases, the tubing
should be secured to the wall with self-adhesive or nail-on tubing clips.
In other cases, it may be practical to run tubing over the top of suspended ceilings. This
helps to run the water longer distances, up to 200 feet, with no tube showing. Running
tubing inside walls should be completely avoided. It is difficult and time consuming,
and does not appreciably improve the appearance of the installation. Please note,
however, that neatness and the appearance of the installation should be a top priority.
When it is necessary to make a hole in the wallboard, make it with a Phillips
screwdriver, rather than an electric drill. This will prevent hitting electrical wiring,
telephone wiring, or a water supply. If you must use a drill, be certain of what is on the
other side of the wall, then proceed.
Suprema 2001 - Operation & Service
1. Connect the tubing to the inlet of the water filter.
a) Most filters have an arrow to indicate the direction of the water flow.
2. Connect a section of tubing to the water filter outlet, and run it to the inlet
of the machine.
a) Insert the tubing into the outlet side of the water filter and secure.
b) Coil an extra 18 inches (45 centimeters) of tubing behind the coffee maker
to allow for repositioning of the coffee maker.
c) Do not connect to the machine at this point.
3. Turn off the valve on the water filter head.
a) Some water filters may not be equipped with an inline valve. If this is the
case, it is recommended that one be installed prior to continuing.
4. Open the valve at the main water source.
5. Bleed the water lines.
a) Turn on the valve at the water filter and catch the first gallon (4 liters) of
water. This will remove any stagnant water and air from the line.
6. Turn off the valve on the water filter head.
7. Connect and secure the tubing to the inlet fitting of the machine.
a) Apply a fitting to the inlet at the rear of the coffee maker, using Teflon
tape. Keep in mind that Teflon tape should be applied in a clockwise
direction.
8. Test for any leaks.
a) Plug in the machine, and switch the power "
b) Listen for the sound of the tank filling.
c) Check all fittings for any leaks, and tighten where necessary.
July 6, 2001
".
ON
Page 11 of 60