Table of Contents
Advertisement
SUPREMA 2001 - OPERATION & SERVICE MANUAL
PRIMING THE CHOCOLATE PUMP
!
Note:
If you are only
topping off the
chocolate syrup
container, it will
not be necessary
to prime the
chocolate pump.
However, if the
container is
completely empty
of syrup, the
chocolate pump
will definitely need
to be primed.
SYSTEM STATUS INDICATORS
!
Note:
There is a flashing
red LED located
on the rear circuit
board. This
flashing is normal
and does not
indicate a fault
with the system. It
indicates that the
system is running
properly.
Suprema 2001 - Operation & Service
When a hot chocolate equipped Suprema coffee maker is being initially set-up, or when
the chocolate container in the unit gets replaced, air pockets will get trapped inside the
pump. These air pockets should be flushed out before the unit is put in service,
otherwise the amount of syrup being dispensed will be inconsistent on the first few of
cups. It will be necessary to prime the chocolate through the pump by following these
steps.
1. To prime the chocolate pump:
a) Press the red "
brewer will cycle and stop with the brew chamber in the raised position.
b) Press the "
keep it pressed for approximately five seconds.
c) At this point, the chocolate pump will cycle four times automatically. No
water will be dispensed until the four cycles have been completed. After
the cycles are completed, the chocolate valve will open for about two
seconds to rinse the whipper bowl and chocolate hose.
A feature has been included on this software version that will indicate the system's
status. There are indicator symbols on the bottom right corner of the LCD that will
always appear. The symbols are outlined below.
SYMBOLS
—
|
+
*
If any one of these symbols is permanently fixed on the bottom right of the display, and
does not toggle to the other symbol, the microprocessor is "frozen". To reset the
microprocessor, switch the power to the coffee maker off for about ten seconds, and
then switch the power on again.
If this does not solve the problem, please contact a technical representative in the VKI
Technical Services Department who may be able to assist.
" button on the inside door panel. The
OPEN BREWER
" button on the front selection panel, and
HOT CHOCOLATE
MEANING OF SYMBOLS
When these two symbols toggle from one to the other -
microprocessor is OK and heater is off (temperature of water
is at proper level)
When these two symbols toggle from one to the other -
microprocessor is OK and heater is on (temperature of water
is not yet at proper level)
July 6, 2001
Page 31 of 60
Advertisement
Table of Contents
