Wan Service Configuration; Ppp Configuration; Ppp Bridged; Ppp Bridged Remote Site Configuration - Patton electronics IPLink 2603 Getting Started Manual

Models 2603, 2621, and 2635 Getting Started Guide
Once all options have been selected, click on the
Additionally, save the configuration by going to the System Configuration > Save menu.
This concludes the E1 interface configuration via the web browser, go to section
on page 52 for instructions on router/bridge and WAN service configuration.
WAN Service Configuration
The IPLink Series Routers offer various WAN services for the proper transport encapsulation: Ethernet, Frame
Relay, and PPP options. The Ethernet option is PPPoE, bridged only. Frame Relay and PPP can be used in
either bridged or routed applications.
PPP Configuration

PPP Bridged

PPP Bridged Remote Site Configuration. The IPlink series routers can be configured as bridges; in this situ-
ation the IPlink typically is at the customer premise or branch office and connects to a router or bridge at a ser-
vice provider location (this can be another IPLink router). This application shows configuration for two
IPLink units in bridged mode. If using a third party router at the Central side, review the router's configuration
for connection to a remote bridge. (See
Remote
PC
IP Address: 192.168.100.11/24 IP Address: 192.168.100.11/24
Gateway: 192.168.100.2
IPlink series (Remote)
First configure the IP address on the Ethernet port (interface ip1) for 192.168.100.2/24 via the command line
(CLI). Once this is done, you can complete the configuration using the web pages.
1. Bring up the web-page management system on your browser by entering the IP address of IPLink.
2. On the Menu, go to Services Configuration, then to WAN. Delete the factory default WAN services already
defined.
3. Click on Create a new service in the main window, select "PPP bridged" and click on the

WAN Service Configuration

Configure and Activate
figure 27.)
IPLink router
IP Address: 192.168.100.2
Figure 27. PPP Bridged Application
button at the bottom of the screen.
"WAN Service Configuration"
Central
IPLink router
IP Address: 192.168.100.3
6 • WAN Services
PC
IP Address: 192.168.100.229/24 IP Address: 192.168.100.229/24
Gateway: 192.168.100.3
button.
Configure
52