Changing User Settings; Controlling Login Access; Controlling User Access - Patton electronics IPLink 2603 Getting Started Manual

Models 2603, 2621, and 2635 Getting Started Guide
Note No check is made for any current password which may have been set for the
user.
If you wish to change the password for another user, enter the command:
user change <username>
This command logs you into the system as another user. You can then use the user password command to
change the password for this user.
Note Changing to another user means that you lose all superuser privileges.
Note Only superusers can use the user change command.

Changing user settings

To change any of the default settings for a user, use the following commands. For example, to change the set-
tings for user fred:
system set user fred access {default|engineer|superuser}
system set user fred maydialin {enabled|disabled}
system set user fred mayconfigure {enabled|disabled}
For example, to change the security level for fred, enter:
system set user fred access engineer
Note
Only superusers can use the user change command.

Controlling login access

To set user login access for user username, use the command (all on one line):
system set login < username > access {default|engineer|superuser}

Controlling user access

To set user access for user username, use the command (all on one line):
system set user < username > access {default|engineer|superuser}
Administering user accounts
E • Command Line Interface (CLI) Operation
133