Connecting Isdn Terminals And Nt To The Smartnode's Isdn Bri Ports; Connecting The 10/100Base-T Ethernet Lan And Wan Cables - Patton electronics SmartNode 4630 Series Getting Started Manual

SmartNode 4630 Getting Started Guide
Connect the cables in the following order:
CAUTION
1. Connect the ISDN terminals and NT to the BRI ports (see section
to the SmartNode's ISDN BRI
2. Connect the 10/100Base-T Ethernet LAN and WAN (see section
net LAN and WAN cables"
3. Connect the power mains cable (see section

Connecting ISDN terminals and NT to the SmartNode's ISDN BRI ports

The SmartNode comes with five ISDN BRI ports located on the rear panel (see
can be connected to the PSTN (ISDN NT) or terminals.
CAUTION
Note
We recommend connecting the PSTN to BRI 0/0 and a terminal to BRI 0/1
to benefit from the lifeline function.
For details on the BRI port pinout and ISDN cables, refer to
D, "Port pin-outs" on page 52.

Connecting the 10/100Base-T Ethernet LAN and WAN cables

The SmartNode 4630 has automatic MDX (auto-crossover) detection and configuration on all Ethernet ports.
Any of the ports can be connected to a host or hub/switch with a straight-through wired cable.
1. Connect to the subscriber port of the broadband access modem (DSL, cable, WLL) to ETH 0/0.
2. Connect port ETH 0/1 to your LAN.
For details on the Ethernet port pinout and cables, refer to
D, "Port pin-outs" on page 52.
Installing the gateway router
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
ports").
on page 26)
"Connecting the power supply"
When this device is used in North America, it shall be connected
to a Network Termination Device and not connected directly to
an outside POTS line.
3 • SmartNode installation
"Connecting ISDN terminals and NT
"Connecting the 10/100Base-T Ether-
on page 27)
figure 2
Appendix C, "Cabling"
Appendix C, "Cabling"
on page 15). All ports
on page 48 and Appendix
on page 48 and Appendix
26