Power Connector Location On Rear Panel (Model 2603/T Shown) - Patton electronics IPLink 2603 Getting Started Manual

Models 2603, 2621, and 2635 Getting Started Guide
Figure 12. Power connector location on rear panel (Model 2603/T shown)
CAUTION
3. Verify that the AC power cord included with your IPLink router is compatible with local standards. If it is
not, refer to chapter 13,
a compatible power cord.
4. Connect the male end of the power cord to an appropriate power outlet.
5. Verify that the green Power LED is lit (see
6. Unplug the AC power cord from the IPLink Series router to power down the unit.
Hardware installation
The IPLink router power supply automatically adjusts to accept
an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
"Contacting Patton for assistance"
figure
on page 112 to find out how to replace it with
13).
3 • Initial Configuration
35