Lan Status; Wan Status; Hardware Status; Defined Interfaces - Patton electronics IPLink 2603 Getting Started Manual

Models 2603, 2621, and 2635 Getting Started Guide

LAN Status

There are two hyperlinks, LAN Settings... and DHCP Server Settings..., which go to the 'LAN Connections' and
'DHCP Server' webpages, respectively. The other parameters shown in LAN Status are as follows:
• Local IP address: the IP address of the Ethernet port.
• LAN subnet mask: the subnet mask of the Local IP address.
• Act as Local DHCP Server: indicates 'Yes' or 'No' as to whether the DHCP server is enabled or disabled. An
enabled DHCP server provides IP addresses to DHCP clients attached to the Ethernet port.
• MAC address: the MAC address of the Ethernet port.

WAN Status

Displays the basic parameters and status of the WAN port service and a link to the WAN Services configura-
tion web page.
• IP Address Type: indicates whether the IP address of the WAN service is statically assigned or as a DHCP
client.
• Default gateway: the gateway defined by the 'IP Routes' submenu item under 'Services Configuration' in
the Configuration Menu.
• Primary DNS: DNS client is currently not available.

Hardware Status

The definitions of the parameters are as follows.
• Up-Time: this is the time since the IPLink was last rebooted, either soft or hard power cycle.
• Current Time: the time is derived from one of two sources. If the IPLink is configured as an SNTP client,
the time is from an SNTP server. If the SNTP client is not configured, the time derives from the Clock Set-
ting as set by the user. The Clock Setting is found in the 'SNTP Client' configuration page.
• Version: lists the version of the operating software in the IPLink. The version information is more detailed
than is listed on the Home webpage of the IPLink.
• Set Time...: a link to the SNTP Client configuration page.
Defined Interfaces
Provides links to operating statistics of the defined interfaces.
System Status
12 • System Status
110