Configuring The Desired Ip Address; Factory-Default Ip Settings; Login; Changing The Wan Ip Address - Patton electronics SmartNode 4960 Series Getting Started Manual

T1/e1 pri voip router
Hide thumbs Also See for SmartNode 4960 Series:
Table of Contents

Advertisement

SmartNode 4960 Getting Started Guide
2. Configuring the desired IP address

Factory-default IP settings

The factory default configuration for the Ethernet interface IP addresses and network masks are listed in
Both Ethernet interfaces are activated upon power-up. LAN interface ETH 0/1 (LAN) provides a default
DHCP server, the WAN interface uses DHCP client to automatically assign the IP address and network mask.
Table 7. Factory default IP address and network mask configuration
WAN interface Ethernet 0 (ETH 0/0)
LAN interface Ethernet 1 (ETH 0/1)
DHCP address range
If these addresses match with those of your network, go to section
work"
on page 32. Otherwise, refer to the following sections to change the addresses and network masks.
Note
For configuring the IP address of the integrated WAN interface (G.SHDSL),
please refer to Chapter 5,

Login

To access the SmartNode, start the Telnet application. Type the default IP address for the router into the
address field: 192.168.1.1. Accessing your SmartNode via a Telnet session displays the login screen. Type the
factory default login: administrator and leave the password empty. Press the Enter key after the password
prompt.
login:administrator
password: <Enter>
192.168.1.1>
After you have successfully logged in you are in the operator execution mode, indicated by > as command line
prompt. With the commands enable and configure you enter the configuration mode.
192.168.1.1>enable
192.168.1.1#configure
192.168.1.1(cfg)#

Changing the WAN IP address

Select the context IP mode to configure an IP interface.
192.168.1.1(cfg)#context ip router
192.168.1.1(ctx-ip)[router]#

2. Configuring the desired IP address

IP Address
DHCP
192.168.1.1
192.168.1.10–192.168.1.99
"3. Connecting the SmartNode to the net-
"G.SHDSL Basic Configuration"
4 • Initial configuration
Network Mask
DHCP
255.255.255.0
255.255.255.0
on page 38.
table
7.
31

Advertisement

Table of Contents
loading

Table of Contents