Rigol DS1000C User Manual page 129

Menus and operations of Cursor Measurements
1. Manual Mode
Figure 2-120 Table 2-79
Menu
Mode
Type
Source
In this mode, the oscilloscope measures the cursors' coordinate values for Y or X,
and the increment between the two cursors.
To do manual Cursor Measurements, please do as the following steps:
1. Select the Manual mode for cursor measurement by pressing soft button as:
Cursor→Mode→Manual.
2. Select channel Source for measurements by pressing soft button as:
Cursor→Source→CH1, CH2, MATH (FFT), or LA (Mixed Signal Oscilloscope)
NOTE: While measuring the channel of MATH, the results are valued with "d"
(division) as units.
3. Select the cursors type by pressing soft button as Cursor→Type→X or Y.
4. Move the cursors to adjust the increment between the cursors: (Details in the
following Table)
© Copyright RIGOL Technologies, Inc. 2007.
Settings
Adjust the cursor to measure X/Y
Manual
parameters manually
Shown as vertical line to measure the
X
horizontal parameters
Shown as horizontal line to measure
Y
the vertical parameters
CH1
CH2 Select the measurement signal source.
MATH (LA is only applicable in Mixed Signal
FFT Oscilloscope)
LA
User's Guide for DS1000 Series
Comments
RIGOL
2-99