Rigol DS1000C User Manual page 125

Using Automatic Measurement as the following steps demonstrate:
1. Select the signal channel for measuring. You could select CH1 or CH2 according
to the signal you are interested in.
Press soft buttons as follows: Measure→Source→CH1 or CH2.
2. To see all measurement value, set the Display All to ON. 18 measurement
parameters will be displayed on the screen.
3. Select parameters page for measuring. You could select voltage or time
parameters pages by pressing soft button as follows: Measure→Voltage or time
→Vmax, Vmin......
4. To get the measured value on the screen. You could select the parameters you
are interested in by pressing the soft button on the right of the menu, and read
the data on the bottom of the screen.
If the data is displayed as "*****", it means the parameter cannot be measured
in current condition.
5. Clear the measure values: press Clear. Now, all of the auto measure values
disappear from the screen.
Figure 2-116
© Copyright RIGOL Technologies, Inc. 2007.
Clear measured data from screen
Turn on/off the mass measurement
User's Guide for DS1000 Series
RIGOL
2-95