Rigol DS1000C User Manual page 108

RIGOL
Pass/Fail
The pass/fail function can monitor changes of signals and output pass or fail signals
by judging the input signal is within the pre-defined mask or not.
Press Utility→Pass/Fail to go to the following menu.
Figure 2-93 Table 2-58
Menu
Enable Test
Source
Operate
Msg display
Figure 2-94 Table 2-59
Menu
Output
Stop
on Output
Mask Setting
2-78
Setting
ON Turn on Pass/Fail test
OFF Turn off Pass/Fail test
CH1 Select Pass/Fail test on CH1
CH2 Select Pass/Fail test on CH2
Pass/Fail test stopped, press to run
(RUN)
■ (STOP) Pass/Fail test running, press to stop
ON Turn on
display
OFF Turn off
display
Settings
Fail Output
detected
Output and beep when Fail
Fail +
condition detected
Pass Output
detected
Output and beep when Pass
Pass +
condition detected
ON Stop test when output occur
OFF Continue test when output occur
Go to mask setting menu
© Copyright RIGOL Technologies, Inc. 2007.
User's Guide for DS1000 Series
Comments
Pass/Fail information
Pass/Fail information
Comments
when Fail condition
when Pass condition