Rigol DS1000C User Manual page 118

RIGOL
Service
Press Utility→Service to go to the following menu.
Figure 2-107 Table 2-71
System Info
Screen Test
Color Test
Key Test
1. System Info:
Press this soft button to display the information of oscilloscope. It contains Model,
Power up times, Serial No., Software version and Installed module of the oscilloscope.
And you could follow the prompting message of "<<Press 'RUN' Key to Exit the
Test>>" to exit this interface.
2. Screen Test:
Press this soft button to run Screen Test program. The screen turns black or white in
sequence (Mono) and the screen turns red, green and blue in sequence (Color) when
keep pressing the RUN/STOP button. You could check the screen for display failures.
3. Color Test:
Select Color Test into color test screen, the hue, saturation, brightness, or red, green
and blue components can be adjusted by turning (
( ) knob.
4. Key Test:
Press this soft button to run Keyboard Test program and start the keyboard test
routine. The blocks represent the buttons on the front-panel; the rectangular boxes
with two arrows beside represent the knobs on the front-panel; the square boxes
represent the pressing function for the
and check the blocks on the screen response whether or not.
2-88
Menu
Press to display system information.
Press to run screen test program.
Press to run color test
Press to run keypad test program.
User's Guide for DS1000 Series
Settings
), confirm selection by pushing
knobs. Test all keys and knobs,
© Copyright RIGOL Technologies, Inc. 2007.