Motor Connections; Plugging In Motor - Craftsman Contractor 113.299112 Owner's Manual

6. Reinstall motor pulley the same way it was when you BELT
aligned the belt. Tighten setscrew. MOTOR
pULLE_"_'_
!!
7, Place belt on SAW PULLEY,..insert end of belt ._'_ _'_ -_
U
through opening in END of guard.
8, Slip belt over motor pulley, _
<14
9. Press guard onto support so that bottom of guard is
approximately 3/4 in. away from belt.
NOTE: To remove guard, lift up on LONG TABS of
clips...pull guard outward. The clips should remain _
on the BELT GUARD SUPPORT.
MOTOR CONNECT|ONS
!
t
3_"CLEARANCE
I
i WARNING: For your own safety, never connect I
|
plug to power source outlet until all assembly
steps are completed,
!. Open motor connector box cover located on side of
motor using a flat blade screwdriver.
WARNING: To avoid electrocution, never connect
anything but the ground wire (colored green) to
the green screw.
2, Remove GREEN SCREW and insert through round
metal terminal on the end of the GREEN wire of
power cord.
3. Reinsert GREEN SCREW in threaded hole that it
was removed from and tighten securely.
GREEN WIRE
TO GREEN SCREW
STRAIN RELIEF
GROOVE (BOI-rOM)
BLACK WIRE TO SPADE
TERMINAL BESIDE
COPPER POST
WHITE WiRE TO SPADE
TERMINAL BESIDE
SILVER POST
4, Insert terminal end of BLACK wire on spade terminal
next to copper post on the motor. Push terminal firm-
ly until seated.
5. Insert terminal end of WHITE wire on spade terminal
next to silver post on the motor. Push terminal firmly
until seated.
& Close motor connector box being sure that power
cord is seated in strain relief groove and tighten box
cover screws.
7. Do not plug in power cable,
_ i
PLUGGING IN MOTOR
EXTENSION REMOVED FOR PICTURE CLARITY
!, From among the loose parts, find two wire ties.
2. Route motor cord along right side of cabinet and
snap ties in 1/4" hole in side of cabinet. Secure two
cords in wire ties.
3. Plug motor cord into outlet on switch box.
iMPORTANT: During table saw cutting operations
the motor must always be plugged into the switch
box. Never by-pass the switch box and plug the
table saw motor directly into a power supply outlet.
37
? WIRE TIES
\