Advertisement
2. Placesawon legssothatholesin bottonofsaw
line up with holesin top of legs.
3. Installscrews,washers, I ockwashers andnuts
asshown.
If you mount the saw on any other bench, make sure
that there is an opening
in the top of the bench the
same size as the opening in the bottom of the saw so
that the sawdust can drop through.
Recommended
working height is 33 to 37 inches from the top of the
saw table to the floor.
SAW BASE
T
HEX
HEAD
SCREW
_"-_1
FLAT
WASH
ER-----_
=;_
1
END
STIFFENER--_I
I
FLAT WASHER ---'-_
LOCKWASHER
-"__
HEX NUT/_
13
2-3/4
7/16 DIA. HOLES
11-1/4
--
10-1/4
--
OPENING
16
FRONT OF SAW
_
r_--
NOTE:
All dimensions
in inches
13
1/2
CHECKING
TABLE
INSERT
1. Insert should
be flush with table top along its
entire length. Check as shown. Loosen flat head
screw that holds insert and adjust the four set
screws as necessary. Tighten flat head screw. Do
not tighten screw to the point where it deflects the
insert.
3/32 IN
SETSCREW
WRENCH
2. To remove
insert.
A) Loosen
Screw
B) Lift insert
from
end, and pull toward
front
of
saw.
3. To replace
insert.
Place insert
into insert
opening
in table and push
toward
rear of saw to engage
spring
clip and until
keyslot
in insert
will drop
over screw.
Tighten
screw.
Do not tighten
screw
to the point
where
it will
deflect
the insert.
Advertisement
