Advertisement
3. Loosen two motor base clamp screws..,
push
motor in as far as it will go.
4. a. Plug in saw, turn MASTER switch "ON".
b. Press
_
key.
c. Press and hold
I__
key to lower blade even
with table top.
d. Turn MASTER switch "OFF',, remove yellow key
and unplug saw.
5. Install belt on motor pulley and saw pulley.
6. Sight along edges of both pulleys
and move
motor pulley so that belt is parallel to the edges
of both pulleys..,
tighten the setscrew
in the
motor pulley.
7. Make sure blade is 90° to table..,
raise it all the
way up using procedure in Step 4 except holding
the
_
key.
8. Lift motor until edge of washer is even with end
of slot..,
tighten
pivot screw. In this position,
pull motor toward
you (pins will
slide out of
cradle)
until belt is TIGHT...
tighten the two
MOTOR BASE CLAMP SCREWS.
9. Loosen Pivot Screw slightly.
10. Lower the saw blade all the way down following
procedure
in Step 4 above.
11. IMPORTANT:
Motor
should
pivot
freely
BASE j
EDGE OF WASHER
EVEN WITH
OFSLOT
-BELT
MOTOR
PULLEY
"PIVOT SCREW
/
downward
as blade is lowered.
If it does not,
LOOSEN the PIVOT SCREW some more.
12. Pivot screw must be adjusted only tight enough
to allow motor to pivot FREELY as blade is raised
or lowered. This will maintain constant tension
on belt.
13. Remove belt from motor pulley.
Insert end of
belt through
opening
in end of belt guard and
install belt on pulley.
BELT
14. Press guard
onto
support so that bottom
of
guard is approximately
3/4 in. away from belt
with blade all the way down.
NOTE: To remove guard, lift up on LONG TABS
of
clips .... pull
guard
outward.
The
clips
should remain on the BELT GUARD SUPPORT.
!
3/4
IN.
21
Advertisement
