Advertisement
22.Carefullymovefenceagainstblade.
23.Movefront bar until ,'0" mark on ripscale
is
approximately
inline with indicator.
Move
FRONT
bar
upwards
until
fence
is
approximately
1/32 in. above table..,
tighten
screw at left end of bar.
NOTE:
Fold a piece of newspaper
making
8
thicknesses
and place between rip fence and
table to act as a spacer. This wil! hold the fence
off of the table approx. 1/32 in.
24. Adjust
rear
bar
so
that
the
fence
is
approximately
1/32 in. above table. Make sure it
is square with fence guide bar rod ...
tighten
screw at end of bar.
25. Replace 3 screws in rear of table extension..,
be
sure top surface of extension
is PARALLEL
to
top
surface of rear guide bar.
8THICKNESSES
OF PAPER
8 THICKNESSES
OF PAPER
26. Move fence to RIGHTedge
ofsawtable..,
make
sure it is approx. 1/32 in. above table at front and
rear and tighten screws
n front and rear guide
bars.
ALIGNING
RIP FENCE
The fence should
slide easily along the bars and
always
remain in alignment
(parallel to sawblade
and miter gauge grooves).
Thealignment
is maintained bya spring underneath
the fence which bears against the fronl guide bar.
To move the fence,
loosen the lock
handle and
grasp
the
fence
with
one
hand
at the
front.
14
Advertisement
