Advertisement
Feedthe workpiece by handalongthe AUXILIARY
FENCE untilthe endis approx.1 in. pastthe front
edgeof the table.Continue tofeedusingthe PUSH
BLOCK.
Holdtheworkpiece i_ ,_osition andinstall t hePUSH
BLOCK by sliding it on top of the AUXILIARY
FENCE/WORK SUPPORT (ThisMayRaise Guard).
Narrow stripsthickerthantheAuxiliaryFence/Work
Supportmayenterthe guardandstrike the baffle.
CAREFULLY raiseguardonly enoughto clearthe
workpiece. U sePUSHBLOCKto completecut.
BAFFLE
In th is exam pie a 14" wide board will be cut down the
center.
Have saw calibrated.
Have guard in position.
STEP 1- Position the board so the usuable
piece
will be 7 inches between the blade and the
fence.
STEP 2- Adjust the fence against the board so it is
parallel to the saw blade. Lock the fence in
position.
STEP 3- Turn
MASTER
switch
"ON"
and press
key. Press number keys iT]
[_
__
(decimal equivalent of 7/8
inches.)
key. The blade will
Press
automatically
raise to the programmed
height. Blade elevation
will be displayed.
STEP 4- Firmly hold the board in cutting
position.
Turn on the saw motor.
STEP5-Guide
the
board
{hrough
the
blade.
Pushing
only on the piece between blade
and the fence.
STEP 6- Turn the motor "OFF". Wait for the blade
to stop before removing the boards.
STEP7-Press
_
key.
Press
number
key
Press _
key. The blade will
lower automatically
until it is even with the
table.
WORKPIECE
37
Advertisement
