Advertisement
8. Raise Blade Guard
.lift
up both
ANTIKICKBACK PAWLS... insertoneof the
SETSCREW WRENCHES i n the notches to hold
the pawlsout of the way.
9. Lay blade of square or other straightedge
alongsideof blade.
10.LoosenHexHead Screwin GUARD SUPPORT
and movespreaderso that it touchesbladeof
square.., tightenscrew.
11.NOTE;The spreaderis now squarewith the
table and approximately in ine with the
sawblade. The spreader requires further
adjustment t o align it PARALLEL to the blade
and in theMIDDLEof thecut
(KERF) made by
the sawblade.
\
\
\
STRAIGHTEDGE
- HEX HD.
SCREW
12. IMPORTANT:The
SPREADER
must always be
PARALLEL
to the sawblade
in the MIDDLE of
the cut (KERF) made by the sawblade.
NOTE: The spreader is thinner than the width of
the KERF by approximately
six thicknesses
of [
paper.
SPACE EQUAL TO APPROX.
3 THICKNESSES
OF PAPER
KERF
WOOD
BLADE
,%
\
/
SPREADER
SPACE EQUAL TO APPROX.
LOOKING
DOWN ON SAW
3 THICKNESSES
OF PAPER
13. Make two folds in a small piece (6 x 6 in.) of
ordinary
NEWSPAPER
making
three
thicknesses.
The folded
paper will be used as a "spacing
gauge".
14. Place RIP FENCE on table...
CAREFULLY
move it against blade so that it is
parallel to the blade, and just TOUCHES
tips of
saw teeth..,
tighten
RIP FENCE LOCK KNOB
HANDLE.
15. Insert folded
paper between
SPREADER
and
FENCE...
hold spreader flat against fence...
tighten
screws
using
7/16 in. wrench.
Now
tighten
Hex Hd. Screws in Support.
16. To remove BLADE GUARD AND SPREADER,
loosen THUMBSCREW...
DO NOT LOOSEN
OTHER SCREWS.
7/16 IN. WRENCH
\
FOLDED
PAPER
19
Advertisement
