Advertisement
9. Holdrodwithonehandandwitha 1/2in. wrench
or
;)liers start screwing
on ONE of the nuts on y
A TURN OR TWO
..screwon
other nut the
same way.
10. Using TWO 1/2 in. wrenches
or pliers tighten
both of the nuts.
11. Slide the bars so that screws are in the MIDDLE
of the slotted holes.
12. Position
rip fence
over miter
gauge groove,
holding
up the rear end while engaging
front
end with bar..,
lower fence onto table.
13. Plug saw into power outlet.
14. Insert yellow key into MASTER switch and turn
on.
15. Press
_
key. A ,,r,, will be displayed.
16. Press and hold jog key _
to raise sawblade
about 3 inches above table surface. Release key.
NOTE: Display will not show elevation or angle
until saw is "calibrated".
This is described after
assembly is complete.
17. Press _
key.
_)' M _,STER_
_AW MOTOR
[M,.us
PU
IFF
i,
/
YELLOW
KEY
[]
JOG
ELEVATION
BEVEL
KEYS
KEY
KEY
18. Place a square against the blade.
Make sure
square is not touching the TIP of one of the saw
TEETH.
1'9. Press and release _
and
keys.
to bring blade square with table.
20. Turn switch off and remove yellow key.
21. Remove plug from power source.
MAKE SURE SQUARE
IS NOT TOUCHING
TIP OF TOOTH
13
Advertisement
