Advertisement
MAINTENANCE
WARNING:
FOR
YOUR
OWN
SAFETY,
TURN
SWITCH
"OFF"
AND
REMOVE
PLUG
FROM
POWER SOURCE
OUTLET BEFORE MAINTAIN-
ING OR LUBRICATING
YOUR SAW.
Do not allow sawdust to accumulate
inside the saw.
Frequently
blow out any dust that may accumulate
inside the saw cabinet and the motor.
Frequently
clean you cutting
tools with Craftsman
Gum and Pitch Remover.
A coat of automobile-type
wax applied to the table
wil! help
to keep the
surface
clean
and allow
workpieces
to slide more freely.
If the power cord or motor cord is worn or cut, or
damaged in any way, have it replaced immediately.
Make sure the teeth of the ANTIKICKBACK
pawls
are always sharp. To sharpen:
1. Remove blade guard.
2. Rotate pawl toward
rear of spreader
so that
teeth are above top of spreader.
3. Hold spreader
with left hand and place pawl
ov_ corner
of workbench.
4. Usi_ng a small round file (Smooth Cut) sharpen
the teeth.
\
LUBRICATION
The followin 9 parts should
be oiled occasionally
with SAE No. 20 or No. 30 engine oil.
1. Tilt screw threads and pivot nut. (First Clean
with Craftsman
Gum & Pitch Remover.)
2. Elevation
screw threads
and pivot nut. (First
Clean with Craftsman
Gum & Pitch Remover.)
3. Cradle bearing points.
4. Bearing
points in guard assembly,
miter gauge
and rip fence.
\\
c
GUARD
_
ITER GAUGE
]lie
BEARING
POINTB
O
41
Advertisement
