Advertisement
BEVEL CROSSCUTTING
BEVEL
CROSSCUTTING
is
the
same
as
crosscutting
except that the wood is cut at an angle
other than 90 ° with the flat side of the wood
Adjus! the blade to the desired angle.
Set blade elevation to clear top of workpiece by
1/8". Verify this clearance
by ;)lacing the work
next to the blade.
Use the Miter Gauge in the groove to the RIGHT of
the blade
It cannot be used in the groove to the
LEFT because the blade guard will interfere Hold
the workplece
with
your
right
hand
and the
Iockhand e with your left.
Use the AUXILIARY
FENCE/WORK
SUPPORT for
additional
support
of long workpieces.
Lay
_t across
the
guide
bars
to support
the
workplece
as near to the end as possible.
Use the Hold-Down
Clamp
(Optional
Accessory)
on the miter gauge for greater accuracy.
In this exam!31e a !" x 6" board will be cut on a 30 °
bevel angle.
Have saw calibrated
with tiD of blade even with table
top. Have guard in place.
STEP1-
STEP 2-
STEP 3-
STEP4-
STEP 5-
STEP 6-
Turn MASTER switch on and press
key. Press number
keys
_
_
Press
_
key. Press ___
key. Press
number
keys,
_i_
[_
_
_--_
(the decimal equivalent
of 1-1/4
inches),
Press _
key. The blade will
automatically
raise and tilt to the correct
angle.
Set the miter gauge to the zero position.
Draw a line to the board at the cut-off point
-- long enough for sighting.
Use the miter
gauge in the right side groove. Position the
board against the miter gauge face. Align
the cut-off
point
with
the
Exact-l-Cut
indicator.
Firmly hold the board in this position. Turn
"ON" the saw motor.
Guide the board through
the blade.
Turn the motor "OFF"
Wait for the blade
to stop before
removing
the boards and
returning
the miter gauge to the starting
position.
STEP 7- Press
_
Press number
key
Press
_
key. Press
_
key, Press
numberkey
_
.Press
_
key. The
blade will owerautomatically
until it iseven
with the table and return to 0 ° bevel,
NOTE: If saw blade is tilted more than 45 ° from
vertical,
the
electronic
function
must
be
recalibrated.
See page 29.
WORKPIECE
TAB LE
\
\
\
\
"\
COMPOUND
MITER
CUTTING
COMPOUND
MITER CUTTING,
is a combination of
miter cutting and bevel crosscutting.
The cut is
made at an angle other than 90 _ to both the edge
and the flat side of the wood.
Adjust the miter gauge and the blade to the desired
angle
.. Make sure miter gauge is locked.
34
Advertisement
