Advertisement
ASSEMBLY
ASSEMBLING
STEEL
LEGS
NOTE:
Steel Legs
are
furnished
with
Model
113.290060.
From among the
loose parts,
find the following
Hardware:
24 Truss Head Screws, 1/4-20 x 5/8 in. long (top
of screw is rounded)
24 Lockwashers,
1/4 in. External Type (approx.
dia. of hole 1/4 in.)
24 Hex nuts, 1/4-20 (approx. dia. of hole 1/4 in.)
8 Hex Nuts, 1/2-13 (approx, dia. of hole 1/2 in.)
4 Leveling feet.
Assemble the legs as shown...
1. Insert the Truss Head Screws through
the holes
in the
legs,
then
through
the holes
in the
stiffeners.
MAKE
SURE THE
SCREWS
GO
THROUGH
THE
HOLES
IN
THE
SIDE
STIFFENERS
MARKED
"X".
2. Install the Iockwashers...
screw on the nuts
but do not tighten until completely
assembled.
3. Install leveling feet.
END
STIFFENER
'
ASSEMBLE
SCREWS
THROUGH
HOLES
MARKED "X"
SIDE STIFFENER
,1/2 IN. HEX NUTS
MOUNTING
SAW
1. From among the loose parts, find the following
hardware:
4 Hex Head Screws, 5/16-18 x 1-1/4 in. long.
4 Hex Nuts, 5/16-18
(approx. dia. of hole 5/16
in.)
4 Lockwashers, 5/16 in. External Type (approx.
dia. of hole, 5/16 in.)
8 Flat Washers, (dia. of hole 11/32 in.)
NOTE: Do not lift saw by plastic housing.
Advertisement
