Advertisement
CALIBRATING
THE SAW
FOR ELECTRONIC
OPERATIONS
been an interruption
in power, it will be necessaryto
calibrate
the "zero"
points for the elevation
and
bevel operations.
To do this, perform the steps listed
below.
Whenever the saw has been unplugged
or there has
Calibration Procedure Using 10" Diameter
Sawblade.
1. Plug in the saw and insert yellow key into
NOTE: For calibrating
the saw with a sawblade
or
other cutting
tool that is less the i0" in diameter
refer to the section headed "Calibration
Procedure
for Cutting Tools Less then 10" Diameter"
page 30.
CALIBRATION
REQUIRED
INDICATOR
O_
....
ER
SAW MOTOR
MINUS
TO
LOCK
O
REMOVE
YELLOW
[]
KEY
O
JOG
ELEVATION
BEVEL
KEYS
KEY
KEY
O
\
[]
[]
[]
MASTER switch and turn "ON." Display will
show flashing
C.
2. Press _
key.
3. Press and hold in the _
key to raise blade
until
the
maximum
elevation
is
reached
(indicated
by a distinct
change
in pitch of the
motor.)
Press and hold the
_
key to just
pull blade away from the stop.
4. Press
key.
5. Place a square against table top and the left
side of the sawblade
(be sure that the square
is not resting against a saw tooth).
6. Press and release the
_
and
{_
keys until blade is square to the table.
NOTE: For greater accuracy
make the final
adjustment
into square from the right using
jog key marked I_
the
7. Press the _
key.
8. Press and hold
_
key to lower blade
until the blade is completely
below the table
top.
9. Repeatedly
press and release the
L__
key
to jog blade up until the tip of a saw tooth is
just even with the table top.
NOTE: Final adjustment
should be made with
the blade coming up to the level of the table
top rather than down, for greatest accuracy.
10. Now press the
_
key. The display
will
/_]o_[]J
which is zero elevation.
read
L
_
Pressing
the
_
key will display
{
[]o[]
]. The elevation and bevel operation
will now be calibrated
until the saw is either
unplugged
or there is a power interruption.
When the work session is over, return the
blade to the 0 ° bevel position and the tip of
the 10" sawblade even with the table top
before unplugging
saw. Refer to "Shut Down
Procedure
to Retain Calibration."
With the
saw at this setting, it will only be necessary to
plug the saw in, turn the MASTER switch
"ON" and press the
_
key to calibrate
the saw, next time it is used.
NOTE;
The saw will remain
calibrated
even if the
Master
Switch
is "off"
and
"locked",
as long a3
the
saw
is plugged
in and
there
is no power
interruption.
Advertisement
