Changing The File Format - Sharp MX-2300N Guide Scanner Manual

CHANGING THE FILE FORMAT

The file format for sending an Internet fax is normally set to [TIFF-F]. If the destination Internet fax machine does not
support full mode (it only supports simple mode), follow the steps below to select [TIFF-S].
Internet Fax
Mode Switch
Exposure
Image
Settings
200X100dpi
Resolution
Send Settings
1
Manual RX
Auto
Original
(1)
Internet Fax
File Format
2
When [TIFF-S] is selected, the transmission settings are restricted as follows:
• Resolution: The selections are [200X100dpi] and [200X200dpi]. If [TIFF-S] is selected after [200X400dpi], [400X400dpi] or
[600X600dpi] is selected, the resolution automatically changes to [200X200dpi].
• Send size: Always A4R (8-1/2" x 11"R). If [TIFF-S] is selected after the send size is changed, the send size is
automatically changed to A4R (8-1/2" x 11"R). If a size larger than A4 (8-1/2" x 11") is scanned, the size will
automatically be reduced to A4R (8-1/2" x 11"R). When this format is included in a broadcast transmission, the
image will be transmitted to all destinations at A4R (8-1/2" x 11"R).
• Special modes: When a ratio setting is selected and the original size is entered, Dual Page Scan, Card Shot, 2in1, and
Auto
TIFF-F
File Format
A4
Special Modes
(2)
TIFF-S TIFF-F
(1)
Mixed Size Original cannot be used.
Display the format setting screen.
Address Book
(1) Touch the [Image Settings] key.
Address Entry
Special Modes
(2) Touch the [File Format] key.
File
Quick File
Select the file format.
OK
(1) Touch the key of the desired format.
(2) Touch the [OK] key.
(2)
72