Sharp MX-2300N Guide Scanner Manual page 38

Specifying the size by entering numerical values.
When scanning a non-standard size original such as a postcard or card, follow these steps to specify the original size.
The width can be from 64 mm to 432 mm (2-1/2" to 17"), and the length can be from 64 mm to 297 mm (2-1/2" to 11-5/8").
Scan
Mode Switch
Exposure
Image
Settings
200X200dpi
Resolution
Send Settings
1
Auto
Original
(1)
Scan
Scan Size
Original
Auto
2
2-Sided
Booklet
2-Sided
Tablet
Scan
Original
Auto
X
Manual
Manual
3
System Settings (Administrator): Original Size Detector Setting
This is used to set the size entry screen to "mm units" or "inch units".
Scan
Scan Size
Original
X64 Y64
4
2-Sided
Booklet
2-Sided
Tablet
• When the scan size is specified by numerical values, the send size cannot be specified.
• When the automatic document feeder is used, an original longer that 432 mm (17") can be scanned (maximum length 800
mm (31-1/2")). To scan a long original, touch the [Standard Size] tab in the screen of step 3 and then touch the [Long Size]
key.
☞
Specifying the size using paper sizes
Auto
Mono2/Auto
Colour Mode
TIFF/JPEG
File Format
A4
Special Modes
(2)
100%
Send Size
A4 Auto
Image Orientation
(64 432)
X 64
mm
Y
(64 297)
Y 64
mm
Size Input
Standard Size
(2), (3) (1)
Send Size
Auto
Image Orientation
Display the original settings screen.
Address Book
(1) Touch the [Image Settings] key.
Address Entry
Special Modes
(2) Touch the [Original] key.
File
The automatically detected size appears at the top of the
Quick File
[Original] key.
Touch the [Scan Size] key.
OK
Enter the scan size (original size).
OK
(1) Touch the [Size Input] tab.
(2) Touch the [X] key and enter the X
(horizontal) dimension with the
keys.
(4)
(3) Touch the [Y] key and enter the Y (vertical)
dimension with the
(4) Touch the [OK] key.
Touch the [OK] key.
OK
The specified size appears in the [Scan Size] key.
(page 36)
37
keys.