Warning Messages - Dell PowerEdge R810 Owner's Manual

Message
Write fault
Write fault on
selected drive
Warning: QPI
links operating
in Slow Speed
Mode.
Warning: QPI link
between <Agent X>
Port <Y> and
<Agent X1> <Port
Y1> failed.
Warning: QPI link
between <Agent X>
Port <Y> and
<Agent X1> <Port
Y1> degraded to
half-width.
NOTE:
For the full name of an abbreviation or acronym used in this table, see the
Glossary on the Dell Support website at support.dell.com/manuals.

Warning Messages

A warning message alerts you to a possible problem and prompts you to
respond before the system continues a task. For example, before you format a
diskette, a message will warn you that you may lose all data on the diskette.
Warning messages usually interrupt the task and require you to respond by
typing y (yes) or n (no).
Causes
Faulty USB device, USB
medium, optical drive
assembly, hard drive, or hard-
drive subsystem.
The processor has bent pins.
The processor is not properly
seated on the processor
socket.
Corrective Actions
Replace the USB medium or
device. Ensure that the USB,
SAS backplane, or SATA
cables are properly
connected. See
"Troubleshooting a USB
Device" on page 162,
"Troubleshooting an Internal
USB Key" on page 171, and
"Troubleshooting a Hard
Drive" on page 174.
Reseat the processors. See
"Removing a Processor" on
page 134 and "Installing a
Processor" on page 138.
If the problem persists, see
"Getting Help" on page 195.
About Your System
57